Remote Alarm Panel Vr-7017 - Furuno VR-7000 Installation Manual

2. WIRING
2.4

Remote Alarm Panel VR-7017

Connect wiring to the terminal board of the unit, referring to the interconnection dia-
gram at the back of this manual. See appendix 2 for how to fabricate the cable. After
wiring the cable, fix the cable with the cable clamp.
Remote alarm panel (back cover removed)
After fabricating the cable, connect it the connector J101.
Note: When you connect between the DCU and remote alarm panel, see "Notice for
the connection with the remote alarm panel" on page 2-4.
2-14
Fix the cable with this cable clamp.
Connector J101
Pin No. Signal
1 TD_A
2 TD_B
3 RD_H
4 RD_C
5 GND
6 NET_S (24V)
7 NET_C (0V)
8* NC
9* NET_H
10* NET_L
*: No connection
The crimp-on lug is preattached here.
Attach the crimp-on lug to the drain wire
of the cable connected with the DCU.
Fix the ground and drain wire (crimp-on
lug) here.
In/Out
Out
Out
In
In
-
In
-
-
-
-