JVC UX-H100 Service Manual page 15

3.1.11 Removing the cassette deck main motor, and replacing the main belt
(See Fig.26 and 27)
• Prior to performing the following procedures, remove the rear
cover.
• Also remove the CD chassis assembly.
• Also remove the bottom base assembly.
(1) Remove the four screws J retaining the cassette deck
mechanism. (See Fig.22)
(2) Remove the cassette deck mechanism.
(3) Remove the two screws L retaining the main motor from
the back side of the cassette deck and the top side of the
cassette deck.
Caution:
After attaching the main motor, check the orientation of
the motor and the polarity of the wires.
(4) Form the backside of the cassette deck, remove the main
motor and the main belt.
3.1.12 Removing the cassette deck head
(See Fig.28)
• Prior to performing the following procedures, remove the rear
cover.
• Also remove the CD chassis assembly.
• Also remove the bottom base assembly.
(1) Remove the four screws J that retain the cassette deck
mechanism. (See Fig.22)
(2) Remove the cassette deck mechanism and place it so that
the front side faces up.
(3) Remove the solder from the bottom side of the head termi-
nal and disconnect the wire.
(4) Remove the screw U that retains the head.
(5) Remove the screw W that retains the head.
(6) Hold the head and slide it in the direction of the arrow to re-
move it.
L
Fig.26
Fig.27
W U
Fig.28
(No.MB248)1-15
L