Static Routing - Planet WNRT-620 User Manual

5.6.1

Static Routing

After you disable NAT mode, you can enable Static Routing to turn off NAT function of this router and let
this router forward packet by your routing policy.
Parameters Description
Check this box to enable Static Routing function, unselect this box if you
Enable Static Routing
don't want to turn off NAT function of this router.
Type the Destination LAN IP address you use to access the Internet. Your
Destination LAN IP
ISP or network administrator provides you with this information.
Type the subnet mask for your network. If you do not type a value here, your
Subnet Mask
ISP or network administrator provides you with this information.
Type the gateway address of your network. Your ISP or network
Default Gateway
administrator provides you with this information.
Hop Count Input which hop count you want to apply to this configuration.
Interface Select the interface which you would like to use LAN / WAN.
Click to add a configuration to the Current Static Routing Table at the bottom
Add
of this page.
Reset Click "Reset" will clear your current settings to allow you to enter again.
Current Static Routing Table
If you want to remove some Destination LAN IP address from the "Current
Delete Selected Static Routing Table", select the Destination LAN IP addresses you want to
remove in the table and then click "Delete Selected".
Delete All If you want remove all Destination LAN IP addresses from the table, just click
this button.
- 50 -