Operating Modes; Scan Mode - Datalogic QuickScan Lite QW2400 Quick Reference Manual

Operating Modes

Scan Mode

The imager can be set to operate in one of several scanning
modes. See the PRG for more information and settings for
any of the options:
Trigger Single (Default) —
ical handheld reader operation. When the trigger is pulled,
illumination is turned on and the scanner attempts to read
a label. Scanning is activated until one of the following
occurs:
• the programmable "maximum scan on time"
elapsed
• a label has been read
• the trigger is released
Trigger Pulse Multiple —
is pulled and continues after the trigger is released, until
the trigger is pulled again or until the programmable "max-
imum scan on time"
disable scanning. Double Read Timeout
sired multiple reads while in this mode.
Trigger Hold Multiple —
ning starts and the product scans until the trigger is
released or "maximum scan on time"
ing a label does not disable scanning. Double Read Time-
1
out prevents undesired multiple reads while in this mode.
Always On —
is always ready for code reading. Double Read Timeout
prevents undesired multiple reads.
Flashing —
regardless of the trigger status. Code reading takes place
only during the Flash On
vents undesired multiple reads.
1. See the Product Reference Guide (PRG) for these and
other programmable features
2. Controlled by Flash On Time and Flash Off Time. Use the
PRG to program these options.
24
1
has elapsed. Reading a label does not
The illuminator is always ON and the reader
The reader illuminator flashes on and off
This mode is associated with typ-
Scanning begins when the trigger
When the trigger is pulled, scan-
2
time. Double Read Timeout
1
prevents unde-
1
has elapsed. Read-
QuickScan™ Lite QW2400
1
has
1
1
pre-