Programming; Using Programming Bar Codes; Configure Other Settings; Resetting Product Defaults - Datalogic QuickScan Lite QW2400 Quick Reference Manual

Programming

The reader is factory-configured with a set of standard
default features. After scanning the interface bar code
from the Interfaces section, select other options and cus-
tomize your reader through use of the programming bar
codes available in the Quickscan Lite QW2400 PRG. Check
the corresponding features section for your interface, and
also the Data Editing and Symbologies chapters of the
PRG.

Using Programming Bar Codes

This manual contains bar codes which allow you to recon-
figure your reader. Some programming bar code labels, like
the "Reset Default Settings" on page 19, require only the
scan of that single label to enact the change.
Other bar codes require the reader to be placed in Pro-
gramming Mode prior to scanning them. Scan an ENTER/
EXIT bar code once to enter Programming Mode; scan the
desired parameter settings; scan the ENTER/EXIT bar code
again to accept your changes, which exits Programming
Mode and returns the reader to normal operation.

Configure Other Settings

Additional programming bar codes are available in the PRG
to allow for customizing programming features. If your
installation requires different programming than the stan-
dard factory default settings, refer to the PRG.

Resetting Product Defaults

If you aren't sure what programming options are in your
reader, or you've changed some options and want your
custom factory settings restored, scan the bar code below
to reset the reader to its initial configuration. Reference
the PRG for other options, and a listing of standard factory
settings.
18 QuickScan™ Lite QW2400