Table of Contents
Advertisement
G E T T I N G S T A R T E D
To Lock The Vehicle:
The driver front door handle has the lock button located on the outside of the handle. With one
of the vehicle's Keyless Enter-N-Go key fobs located outside the vehicle and within 5 ft (1.5m) of
the driver's front door handle, push the door handle lock button to lock all four doors and decklid.
Do NOT grab the door handle, when pushing the door handle lock button. This could unlock the
door(s).
Push The Button To Lock
NOTE:
• If " 1st Press Of Key Fob Unlocks All Doors" is programmed, all doors will unlock when you
grab hold of the driver front door handle. To select between "1st Press Of Key Fob Unlocks All
Doors" and "1st Press of Key Fob Unlocks Driver Door," refer to the "Uconnect Settings" in
"Understanding Your Instrument Panel" in your vehicle's Owner's Manual at
www.chrysler.com/en/owners/manuals/ or "Programmable Features" in this guide for further
information.
• If "1st Press Of Key Fob Unlocks All Doors" is programmed, all doors and decklid will unlock
when you push the decklid button. If "1st Press Of Key Fob Unlocks Driver Door" is
programmed, only the decklid will unlock when you push the decklid button. To select
between "1st Press Of Key Fob Unlocks All Doors" and "1st Press Of Key Fob Unlocks Driver
Door," refer to the "Uconnect Settings" in "Understanding Your Instrument Panel" in your
vehicle's Owner's Manual at www.chrysler.com/en/owners/manuals/ or "Programmable Fea-
tures" in this guide for further information.
• After pushing the Keyless Enter-N-Go lock button, you must wait two seconds before you can
lock or unlock the vehicle using the door handle. This is done to allow you to check if the
vehicle is locked by pulling the door handle, without the vehicle reacting and unlocking.
14
Do NOT Grab The Handle When Locking
Advertisement
Table of Contents
