Keyless Enter-N-Go - Ignition - Chrysler 200 2017 User Manual

KEYLESS ENTER-N-GO — IGNITION
Starting
With a valid Keyless Enter-N-Go key fob inside the vehicle:
• Push the ENGINE START/STOP button once, while pushing the brake pedal. If the engine
fails to start, the starter will disengage automatically after 10 seconds.
NOTE:
In case the ignition switch does not change with
the push of a button, the key fob may have a
low or dead battery. In this situation, a back up
method can be used to operate the ignition
switch. Put the nose side of the key fob (side
opposite of the Emergency Key) against the
ENGINE START/STOP button and push to
operate the ignition switch.
Stopping
1. Bring the vehicle to a complete stop.
2. Shift the transmission to PARK (P).
3. Push the ENGINE START/STOP button
once. The ignition will return to the OFF
mode.
NOTE:
If the transmission is not in PARK and the vehicle is in motion, the ENGINE START/STOP
button must be held for two seconds with the vehicle speed above 5 mph (8 km/h) before the
engine will shut off.
Accessory Positions With Engine Off
NOTE:
The following functions are with the driver's foot OFF the Brake Pedal (transmission in PARK).
Beginning With The Ignition Switch In The OFF Position:
• Push the ENGINE START/STOP button once to change the ignition switch to the ACC
position.
• Push the ENGINE START/STOP button a second time to change the ignition switch to the
ON/RUN position.
G E T T I N G S T A R T E D
Engine Start/Stop Button
15