Case 2: (Peer-To-Peer Mode) Vip-157S Port 1 To Port 2 Communications - Planet VoIP Analog Telephone Adapter VIP-157S User Manual

Case 2: (Peer-to-Peer mode) VIP-157S Port 1 to Port 2 communications

Supposing one VIP-157S connects to two telephones, just pick up phone 1 and dial
'192*168*0*1**5062', phone 2 will ring.
Analog telephone sets are connected to the phone (RJ-11) ports of VIP-157S respectively
1 9 2
Test the scenario:
1. Pick up the telephone set on VIP-157S port 1, and you should be able to hear the dial-tone
2. Press the keypad: 192*168*0*1**5062# shall be able to connect to the VIP-157S port 2
3. Then the telephone set in VIP-157S port 2 should ring. Please repeat the same dialing steps on
port 2 to establish the first voice communication from VIP-157S
Hint
192.168.0.1
1001
* 1 6 8 *
If the IP address of the remote calling party is known,
you may directly make calls via its IP address and end
with a "#".
If the ATAs are installed behind a NAT/firewall/IP
sharing device for Peer-to-Peer VoIP application,
please make sure the NAT device support SIP
applications, and suitable settings should be applied
to the NAT device to enable the SIP communications
before making calls
[VIP-157S] in PLANET ATA series products, to connect
to remote ATA, press the keypad in the following
sequence to connect to the remote VIP-157S port 2:
[remote ATA IP address]**5062, for example:
192*168*0*2**5062
1002
0 * 1 *
*
5 0 6 2 #
50