Table of Contents
Advertisement
Step 1
make holes
To insert the speed dome into the ceiling, first
a hole must be properly made to let the dome
be through for hanging.
The best way to decide the diameter of the
hole, and the spots for mounting screws, is to
use the supplied metal holder.
Put the holder on the surface of the target location and mark a circle with
pencil or color marker
Also mark out the spots for screws with the screw holes on the holder
Cut the camera hole alone with the curve
Drill holes for screw in 6 mm (1/4") on the three marked spots;
Step 2
Integrate the decoration ring with camera
The decoration ring is not just for nice looking,
but also the piece to hold the camera in place
for embedded mounting.
To integrate the ring to camera:
Take the transparent dome cover off
1.
Locate the ring to the bottom side of the
2.
cover
Put the cover back to the camera
3.
Step 3
Mount the camera through the hole
Take the below steps to make the camera cling
to ceiling:
Place the auxiliary metal bracket onto the
1.
top of the ceiling
Put the camera through out the hole
2.
Align the screw holes of the decoration
3.
ring and the auxiliary bracket
Put screws through and tighten the two
4.
brackets, with the ceiling in between
.
User's manual
5.3 Embed Camera Into Ceiling
.
19
Advertisement
Table of Contents
