Adjusting The Picture Orientation; Rear Projection; Ceiling Mode; Lens Adjustments - Planar PD8130 Installation And Operation Manual

Installation
3.8
Adjusting the Picture
Orientation

Rear Projection

Ceiling Mode

3.9

Lens Adjustments

Focus

Zoom

Lens Shift

If the PD8130/PD8150 is installed behind the screen, you must change the
picture orientation to match the installation method. To do this, press MENU on
the remote control. Then, select System from the Main Menu.
If the projector is used in a rear-projection application (see Figure 3-6), press
➤
repeatedly to select Rear Projection from the System Menu. Press
to On.
If the projector is ceiling-mounted, the PD8130/PD8150 automatically inverts the
➤
image. If this automatic inversion is not desired, select Ceiling Mode from the
System Menu and set it to Off.
The PD8130/PD8150 gives you a great deal of control over the picture size,
position and focus.
To focus the projected image, grasp the
➤
lens by the front ring and rotate it.
To make the picture smaller (zoom out)
➤
or larger (zoom in), rotate the zoom ring
in the appropriate direction.
To access the lens shift controls:
➤
1. Locate the Planar badge at the top
of the projector. Press on the side of
the badge nearest the "P" to release
it.
30 Planar PD8130/PD8150 Installation/Operation Manual
or
Zoom Out
Zoom In
to set it