Operations Commands - Planar PD8130 Installation And Operation Manual

Serial Communications

Operations Commands

Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232
Remote Button
Keyname
asp.narr (none)
pip.sw
pip.1 (none)
pip.2 (none)
pip.3 (none)
pip.4 (none)
pip.5 (none)
pip.off (none)
pip.swap
pow.tog (none)
lit.tog
Operations commands allow more flexible and direct control of the projector.
➤
The syntax for operations commands is as follows:
op <operation> <command>[CR]
(Precede <operation> and <command> with a space.)
The command type can be one of 5 functions:
Function
Set
Get
Increment
Decrement
Execute
IR Code
Set 1 Set 2
0xA1 0xE1
0xA3 0xE3
PIP
0xA4 0xE4
0xA5 0xE5
0xA6 0xE6
0xA7 0xE7
0xA8 0xE8
0xA9 0xE9
0xAA 0xEA
SWAP
0xAC 0xEC
0xAD 0xED
LIGHT
Operations Control Commands
Command
= <value> Makes the unit take that value.
Asks what the current value is.
?
+ Adds 1 to the current value.
- Subtracts 1 from the current value.
(none) Performs an action such as a reset.
70 Planar PD8130/PD8150 Installation/Operation Manual
Description
Apply 4:3 Narrow aspect ratio to the
active source.
Switch to next "PIP Select" state.
Change "PIP Select" to source 1.
Change "PIP Select" to source 2.
Change "PIP Select" to source 3.
Change "PIP Select" to source 4.
Change "PIP Select" to source 5.
Change "PIP Select" to off.
Swap the PIP image with the active
source image.
Toggles between power on and
power off.
Activates remote backlighting only
when pressed momentarily. When
held for five seconds or more, the IR
code for toggling the projector I/O
panel light is transmitted.
Action on unit