Planar PD8130 Installation And Operation Manual page 72

Operation
• 4:3 causes the port to output 12 volts whenever the 4:3 aspect ratio is chosen.
The output stops if PIP is enabled (PIP source is set to anything other than off).
• 4:3 Narrow causes the port to output 12 volts whenever the 4:3 Narrow
aspect ratio is chosen. The output stops if PIP is enabled (that is, the PIP
source is set to anything other than off).
• RS232 causes the port to output 12 volts when an RS232 screen trigger 1 "on"
command is received and stop when a trigger 1 "off" command is received.
The 12 volt output also stops when the projector is turned off.
Trigger 2 (PD8150 only): Select Trigger 2 from the Control menu to configure the
Trigger 2 output. Trigger 2 operates identically to Trigger 1.
Remote Code Set: Select Remote Code Set from the Control menu to specify
the remote IR code set to which the PD8130/PD8150 responds. The default is
Set-1. Choose Set-2 if other equipment in the theater responds to commands
from the PD8130/PD8150 remote control in ways that are unexpected or
undesirable.
When you select a different remote code set on the PD8130/PD8150, you must
re-program the remote control unit to use that same code set. To do this, press
and hold the LIGHT and ENTER buttons simultaneously for approximately five
seconds. When the code set has changed, the remote control back-lighting
"blinks" to visually confirm the change.
Table 6-1 lists the IR codes associated with each remote control button.
Auto Source: This control chooses whether or not to scan for other active
sources if the current source is not available. The default setting is Off.
58 Planar PD8130/PD8150 Installation/Operation Manual