Table of Contents
Advertisement
Monitor with optional Video input function
If your LCD Monitor is with Video input function, the display can be directly connected to a Video
device such as VCR, DVD, camcorder etc. for Video display. The Monitor is compatible with
NTSC/PAL systems.
OSD Menu
The control functions of Video display setting are listed under "Video" function on the Main menu.
Continue pressing the Function buttons to select the Video function. Press the Adjustment buttons
to enter the sub-menu for video control.
Video Control functions
Once the Video function is selected, the input signal source is switched to Video input.
When the Video function is selected from OSD Menu without active Video input signal, you can
use Function control buttons select VGA, CVBS, or S-Video input signal.
When the monitor is in the Video mode, you can scroll through the following functions by continue
pressing the Function buttons.
When the above OSD menu is not active, the following functions are available for quick adjustment.
Optional Video input function
If the input signal is from S-video terminal, this message will be shown
for a few seconds.
If the input signal is from the RCA plug, this message will be shown for a
few seconds.
To adjust the Contrast level of the display.
To adjust the Brightness level of the display.
To adjust the audio volume of the monitor's speakers
To switch from Video mode to VGA input or vice versa.
To adjust colors.
To select full sampling rate (Mode 0) or half sampling rate (Mode
1).
To set the display parameters to the factory set default values.
13
A
D
PPENDIX
Advertisement
Table of Contents
