Wolf WGSC100S Use & Care Manual page 12

USING COOKING MODES
PROGRAM MODES
There are 3 slow cook options in PROGRAM mode: 1) Program one heat and time cycle in one
cook session. 2) Program two heat and time cycles in one cook session. 3) Use the Probe to
set the desired end temperature.
1 PROGRAM
Select one heat and time setting for the entire cooking session. It will switch automatically to
WARM at the end of the cook cycle.
Add food to vessel and cover with lid.
1.
Turn selector bezel to PROGRAM. The LCD screen displays
2.
flashing setting of "1 PROGRAM" and "2 PROGRAMS."
Turn the knob to the left to select 1 PROGRAM. Release the
3.
knob once 1 PROGRAM is selected. The setting will flash three
times before it becomes solid.
NOTE: If the START/STOP button is pressed before the display
stops flashing, the program will go to the next step in the setting
process.
Once "1 Program" becomes solid, the flashing heat settings
4.
of "LOW MED HIGH" will display. Turn the knob left or right to
select LOW, MEDIUM, or HIGH heat. WARM is not an option.
Release the knob once a heat setting is selected; then the
setting will flash three times before it becomes solid.
NOTE: To access the previous setting at any time, press the BACK
button once.
Once selected heat setting becomes solid, the flashing
5.
"COOK TIME" and "00:00" will display. Adjust the time setting
by turning the knob to the right to increase or to the left to
decrease the time. The time adjusts in 30-minute increments,
with a minimum time of 30 minutes and a maximum of 12 hours.
Release the knob once the time is set. The time and START/
STOP button will start to flash.
Press the START/STOP button to start cooking. A long chime
6.
will sound and the START/STOP button will stay illuminated.
The selected cook time becomes solid and the timer will count
down.
When cook time is complete, a long chime will sound. "COOK
7.
TIME" and "00:00" will disappear. The unit will switch to the
"WARM" heat setting and the timer will begin to count up. After
4 hours on WARM, the unit will shut off automatically.
Press the START/STOP button at any time to end cooking and
8.
turn off the unit. "OFF" will flash in the display and the cooker
will chime three times.
NOTE: During the cycle, the heat setting may be adjusted at any
time by turning the knob. The new selected setting will flash three
times before it becomes solid and the temperature adjusts. There
is no need to press the START/STOP button. The time setting
may be adjusted at any point by pressing the TIMER button to
reactivate time to a flashing display, and the knob may be turned
to adjust the cook time.
12