Emc Information; Class A Notice For Fcc - Cisco IR829 Hardware Installation Manual

Hazardous Locations Standards and Marking Strings
The following standards were used for the
hazardous locations approvals and certifications:
ANSI/ASA 12.12.01-2013
CAN/CSA C22.2 No. 60079-0-11 Ed. 2
CAN/CSA C22.2 No. 60079-15-12 Ed. 1
CSA C22.2 No. 213-M1987+A11:2013
EN 60079-0:2012
EN 60079-15:2010
IEC 60079-0 6th Edition
IEC 60079-15 4th Edition
UL 60079-0, 5th Ed, 2009-10-21
UL 60079-15, 3rd Ed, 2009-7-17
The following hazardous locations strings are
provided on the router:
Class 1, Div 2, Groups A B C D
Class I, Zone 2, AEx nA IIC T4 Gc
DEMKO 15ATEX 1491X
Class 1, Zone 2, AEx nA IIC T4 Gc

EMC Information

For EMC and safety information, see the Regulatory Compliance and Safety Information at this URL:
www.cisco.com/go/800

Class A Notice for FCC

Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
2.
This device operates in the : 5150-5250, 5250-5350, 5470-5725, and 5725-5850 MHz bands and may be
operated indoor or outdoors per FCC guidance.
78-100611-01A0
II 3G, Ex nA IIC T4 Gc
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
Getting started with the Cisco 829 Integrated Services Router
9