Lincoln Electric Power Feed 25M Operator's Manual page 41

POWER FEED™ 25M
Parameter
P.28 Display Workpoint as Amps Option
This option determines how workpoint is displayed.
False = The workpoint is displayed in the format defined in the weld set (default).
True = All workpoint values are displayed as an amperage.
Note: This option may not be available on all machines. The power source must support
this functionality, or this option will not appear in the menu.
P.37 USB Memories
Allows operator to scroll through files on a mounted USB drive in the "\Lincoln\Memories"
folder, if files exist in that folder. The operator can then choose a file, and if it is a valid
memory set file, the memories stored in that file will be loaded to the user memories of
the selected head. The operator will be informed of success or failure by a message on
the User Interface.
Note: This option will only appear in the menu if (1) a USB module is in the same group as
the UI and (2) a USB drive has been plugged into the USB port and was properly mounted.
P.38 Save Memories to USB
Allows operator to save the user memories of the currently selected head to a mounted
USB drive. The file name will be automatically generated and saved into the
"Lincoln\Memories\" folder on the USB drive. If the directory does not exist, it will be cre-
ated.
Note: This option will only appear in the menu if (1) a USB module is in the same group as
the UI and (2) a USB drive has been plugged into the USB port and was properly mounted.
P.41 WFS Offset
Allows the operator to adjust the speed of the WD drive rolls. The adjustment can range
from -5% to +5% of normal speed.
On dual-head Power Feed 84 Feeders, a different setting can be used for each head. The
operator will be prompted to select which head to edit before the setting can be changed.
Note: This option may not be available on all machines. The wire drive must support this
functionality, or this option will not appear in the menu.
P.80 Sense From Studs
Use this option for diagnostic purposes only. When power is cycled, this option is auto-
matically reset to False.
False = Voltage sensing is automatically determined by the selected weld mode and other
machine settings (default).
True = Voltage sensing is forced to "studs"
USER DEFINED PARAMETERS
Name and Description
B-25
OPERATION
Range
False, True
Don't use
memory
File1
File2
...
Last File
n/a
-5% to 5% (default
is 0%)
False,
True