User Memories - Lincoln Electric Power Feed 25M Operator's Manual

POWER FEED™ 25M
DUAL PROCEDURE/MEMORY PANEL OPERA-
TION
The Dual Procedure/Memory Panel performs three functions:
• Weld procedure selection
• Memory save and recall
• Limits setting
There are two procedure memories (A and B) and eight user
memories (1-8).
Procedure Memory vs. User Memory
Procedure memory is used while welding. Changes to the weld
procedure (WFS, voltage, UltimArc™ Controll, etc.) immediately
change the contents inside the selected procedure memory.
MEMORIES
PROCEDURE
ARE COPIED TO
MEMORY
PROCEDURE
A GUN B
M
1 2
5
6
User memories work by copying the weld procedure from one of
the eight memories into either the "A " or "B" procedure. Weld
procedures are saved into the memories only when the operator
chooses.
Using Procedure Memories
Procedure memories can be selected by choosing either "A" or
"B" procedure directly with the memory panel, or by selecting
"GUN" and using a dual procedure gun to select between proce-
dure "A" and "B". When selecting procedures with the gun
switch, "A" or "B" will flash to show which procedure is active.
PRESS
TO SELECT
PROCEDURE
A GUN B
M
1 2
5 6
USER
(8) USER
MEMORIES
MEMORY
M
3 4
7 8
M
3 4
7 8

USER MEMORIES

Recall a memory with memory buttons
To recall a user a memory, press one of the six user memory
buttons. The memory is recalled when the button is released. Do
not hold the button for more than two seconds when recalling a
user memory.
Recall a memory with the gun trigger
If desired, memories 1 through 8 can be recalled with the gun
trigger. For example, to recall memory 3, quickly pull and
release the gun trigger 3 times without welding. To recall memo-
ry 1, quickly pull and release the gun trigger 9 times without
welding. Note: the wire feeder is factory set with this feature
disabled. Use the SETUP menu and change P.4 to enable mem-
ory recall with the gun trigger.
Note that memories may be locked with P.C. application soft-
ware to prevent accidental overwrite of the memories. If an
attempt is made to save a memory when memory saving is
locked, the message "Memory save is Disabled!" will appear
briefly in the MSP4 display.
RECALL:
PRESS
1 SECOND
A
GUN B
1
5
B-31
OPERATION
SAVE:
PRESS
2 SECONDS
M
M
2 3 4
6 7 8