Single Desktop - Planar Dome EX User Manual

30 | Dome EX Display

Single Desktop

On Windows systems, the single desktop supports the Dome E3,
Dome E3c, and Dome E5 displays running the Dome DX2 controller.
From one display controller, you can run a single desktop across two
Dome EX displays.
The procedures in this section show you how to complete the initial
installation of single desktop and how to change your system
configuration to move from dual-headed display to single desktop.
On the display controller, switch 3 on the DIP switch must be in
the ON position for each procedure.
To set the display resolution
After you install the display controller and driver, use the Dome tab to
set the display resolution for single desktop.
1 Right-click the desktop, and select Properties > Settings.
The Settings tab appears.
2 Select the Plug and Play Monitor on Dome DX2/PCI Properties from
the Display list. Make sure the box for Extend my Windows desktop
onto this monitor is checked. Click Apply.
3 Select Advanced > Dome.
4 In the resolution field, choose the resolution for single desktop.
5 Click OK until you return to the desktop.