Planar Dome EX User Manual page 17

Set the DIP Switch on the Dome DX2 Board
If you are using the Dome DX2 display controller, you need to enable
or disable VGA mode according to your system configuration. Enable
VGA on only one board when you install multiple Dome DX2 display
controllers. Disable VGA on all Dome DX2 display controllers if you
are using a separate VGA card. For VGA mode, slide switch 1 into
the ON position.
For some Dell systems, you may need to enable VESA modes to see
output on the screen during the boot process. If so, slide switch 2 into
the ON position.
For single desktop mode, slide switch 3 into the ON position.
VIdeo 1 port
Tips
• Access to ports. For displays mounted on a desk stand, rotate the
LCD panel from portrait to landscape for access to the ports.
• Threading cables. Thread the DVI cable and power cord through
the back of the stand. Make sure the cable and cord run through
the notches. To reattach the stand cover, align the hooks with the
slots on the stand. Press the cover into place. A click sound signals
a secure connection.
• Multiple displays. Connect the first display of a two-headed
system, or the only display of a one-headed system, to the Video 1
port. Connect all displays to the controller before you turn on the
computer and install the driver. Use two displays to view two
images simultaneously or one image across both displays.
Installing the Display | 7