Using The Quick Setup - Pioneer XRE3138-A Operating Instructions Manual

5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your system
up and running with just a few button presses.
The receiver automatically makes the
necessary settings after you have selected your
speaker setup, room size and listening
position.
If you want to make more specific settings,
refer to The System Setup menu on page 28.
Use the front panel controls for the steps
below.
PHASE
CONTROL
PHASE DIALOGUE AUTO SURR/
DVD/LD DVD 5.1 TV /SAT
CONTROL ENHANCEMENT DIRECT
SOUND MIDNIGHT/ VSB
RETRIEVER LOUDNESS MODE TONE
STANDBY / ON STANDBY / ON
PHONES
SIGNAL TUNER QUICK QUICK
SELECT DIMMER EDIT SETUP SETUP SETUP RETURN
MULTI JOG
1 If the receiver is off, press
 STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
3 Use the MULTI JOG dial to choose your
subwoofer setting.
Select YES or NO, depending on whether
you've connected a subwoofer.
4 Press ENTER.
5 Use the MULTI JOG dial to choose your
speaker setup.
If you selected YES for the subwoofer setting in
step 3, the following choices are available:
2.1ch – 3.1ch – 4.1ch – 5.1ch
If you selected NO for the subwoofer setting in
step 3, the following choices are available:
2.0ch – 3.0ch – 4.0ch – 5.0ch
VSX-517
MULTI JOG MULTI JOG
ENTER ENTER
STEREO/ ADVANCED
DVR/VCR TUNING STATION
F.S.SURR STANDARD SURROUND
LISTENING MODE
MASTER
VOLUME
DOWN UP
• Check the table below to find the speaker
setup that corresponds with your system.
6 Press ENTER.
7 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large (S, M or L), M being
an average-sized room.
8 Press ENTER.
9 Use the MULTI JOG dial to choose your
listening position.
You can cycle between the following choices:
• FWD – If you are nearer to the front
speakers than the surround speakers
• MID – If you are equal distance from the
front and surround speakers
• BACK – If you are nearer to the surround
speakers than the front speakers
10 Press ENTER to confirm your setup.
The display shows the speaker setup, room size
and listening position that you have selected.
02
7
En