The Other Setup Menu; Dynamic Range Control Setup; Dual Mono Setup; Lfe Attenuator Setup - Pioneer XRE3138-A Operating Instructions Manual

The System Setup menu
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver's COMPONENT
VIDEO MONITOR OUT jacks.

The Other setup menu

The Other menu is where you can make
customized settings to reflect how you are
using the receiver.
1 Select OTHER from the System Setup
menu.
Use / to select the setting you want to
2
adjust then press ENTER.
If you are doing this for the first time, you may
want to adjust these settings in order:
• DRC – Specify the amount of dynamic
range adjustment to Dolby Digital
soundtracks (see Dynamic Range Control
Setup below).
• DUALMONO – Isolate one channel when
listening to discs with dual mono encoding
(see Dual Mono Setup below).
• LFE ATT – Set the attenuator level for the
LFE channel (LFE Attenuator Setup below).
Use / to make the adjustments
3
necessary for each setting, pressing RETURN
to confirm after each screen.

Dynamic Range Control Setup

• Default setting: OFF
Specifies the amount of dynamic range
adjustment to Dolby Digital or DTS
soundtracks:
• DRC OFF – No dynamic range adjustment
(use when listening at higher volume).
• DRC MAX – Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased).
• DRC MID – Mid setting.
Note
1 This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.

Dual Mono Setup

Default setting: CH1
•
Specifies how dual mono encoded Dolby
Digital soundtracks should be played:
• CH1 – Only channel 1 is played
• CH2 – Only channel 2 is played
• CH1 CH2 – Both channels are played
through the front speakers

LFE Attenuator Setup

• Default setting: ATT 0 dB
Set the LFE attenuator as necessary to prevent
ultra-low bass tones (included with some
Dolby Digital and DTS audio sources) from
distorting the sound from the speakers:
• LFEATT 0 – No limiting (recommended
setting)
• LFEATT 10 – 10dB of limiting
• LFEATT ** – No sound from LFE channel
06
1
31
En