ANK Audio Note Kits M3 Phono Board Instruction Manual page 15

If you look on the component side of the board you will see two circles with HT marked on them. Let's wire up the HT
terminal for V1 – do this by using the silver wire to extend.
Copyright © 2007 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
You can see here that I am laying down a length of silver
wire that I will be soldering to for the HT connection.
Here I am inserting the silver wire through the HT hole so
that it will follow the trace and connect to the resistor lead.
On the component side of the board
you will want to bring the silver wire
through, curl it, and clip it so that you
have a nice hook in order to connect to
later!
Page 15