ANK Audio Note Kits M3 Phono Board Instruction Manual page 12

We just need to show you a few more techniques and then you will be well on your way to completing the resistor
connections. How about a break and congratulations so far!
Copyright © 2007 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Once that wiring has been completed of R7 you will want to
update your schematic as shown opposite.
Let's make a connection now to pin 2.
As you can see from the trace on the board the wire must
curl around and connect to pin 2.
Often it will not stretch all the way there so we use the silver
wire to complete the connection (see next two picture for
completion).
As you can see we have curled the lead with the pliers and
now we must extend with silver wire to pin 2 of the valve
base...
Page 12