Configuring Raid Levels; Raid Configuration; Raid Configuration Page Components; Physical Disks Table - Cisco UCS User Manual

Configuring RAID Levels

RAID Configuration

You can use the RAID Configuration functionality to configure the on-board or PCIe supported RAID
controller cards.
If your system has multiple RAID controllers, UCS-SCU displays a list of all available RAID cards, and
physical and logical disks on the RAID Configuration page.
The following RAID configuration options are available:
•
•
•
•
This section includes the following sections:
•
•
•

RAID Configuration Page Components

This section describes the RAID Configuration page and contains the following topics:
•
•

Physical Disks Table

The Physical Disks table in the RAID Configuration page lists the following:
•
•
•
•
•
Automatic setup with redundancy
Automatic setup without redundancy
Single RAID levels—RAID 0, RAID 1, RAID 5 and RAID 6
Nested RAID levels—RAID 10, RAID 50 and RAID 60
RAID Configuration Page Components, page 7-1
Configuring RAID Arrays, page 7-3
Clearing RAID Arrays, page 7-6
Physical Disks Table, page 7-1
Logical Disks Table, page 7-2
ID—The identifying number of the physical disk.
Slot—The slot in which the physical disk belongs.
State—The status of the disk. For more information about the various disk states, go to
Size—The size of the physical disk.
Device Speed—The disk access speed of the controller.
C H A P T E R
Cisco UCS Server Configuration Utility, Release 5.0
7
Table 7-1.
7-1