Install Hardware - AMX DUX-SRX User Manual

INSTALL HARDWARE

WARNING:
Before installation, disconnect the power supplies of all the devices.

Please use quality cables and accessories specified or provided by the

manufacturer.
During installation, connect and disconnect cables with caution.

To install DUX-SRX with an HDBT Transmitter (e.g. DUX-8D) (See Application
Example: System Wiring on Page 11):
1. Connect the HDBT Transmitter (e.g. DUX-8D) selected to input sources (e.g. HDMI
input sources from a Blu-ray Player, cable/satellite TV, media server, etc.).
2. Connect DUX-SRX's HDBT IN to HDBT OUT of the HDBT Transmitter.
3. Connect DUX-SRX's HDMI OUT to an HDMI output device (e.g. a projector).
4. If Audio Output is needed, connect DUX-SRX's S/PDIF (for digital audio signal) or
L/R (for analog audio signal) connector.
5. Connect the included Power Adapter to DUX-SRX.
6. Power on all the devices and start operation.
NOTE:
1) 70m/230ft @4K or 100m/328ft @1080p are maximum transmission distances realizable
when DUX-SRX and other devices are in perfect conditions and the straight cable runs with no
electrical interference, bends, kinks, patch panels or wall outlets, etc. If any of these turns to be
an issue in your installation, transmission distance will be affected.
2) When all set, check the LED indicators of DUX-SRX. For LED indication, please refer to page
08.
10
USER MANUAL - DUX-SRX
100-METER 4K HDBASET SCALING RECEIVER