Specifications - Pioneer Elite VSX-43TX Operating Instructions Manual

Techno Tidbits & Problem-solving

Specifications

Amplifier Section
Continuous average power output of
100 watts* per channel, min., at 8
ohms, from 20 Hz to 20,000 Hz with no
more than 0.09 %** total harmonic
distortion (front).
Continuous Power Output
Front .............. 100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 )
Center ........... 100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 )
Surround ........ 100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 )
Surround Back
.................. 100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 )
Input (Sensitivity/Impedance)
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2 ................... 335 mV/47 k
Frequency Response
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2 ...... 5 Hz to 100,000 Hz
Output (Level/Impedance)
VCR 1/DVR REC, VCR 2 REC, CD-R/TAPE 1 REC,
MD/TAPE 2 REC .................................... 335 mV/2.2 k
Tone Control
BASS ..................................................... ± 6 dB (100 Hz)
TREBLE ................................................. ± 6 dB (10 kHz)
LOUDNESS ........................... +4/+2 dB (100Hz/10 kHz)
Signal-to-Noise Ratio (IHF, short circuited, A network)
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2, MULTI CH IN .......... 101 dB
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2 .................................... 83 dB
* Measured pursuant to the Federal Trade Commission's
Trade Regulation rule on Power Output Claims for
Amplifiers.
** Measured by Audio Spectrum Analyzer.
VIDEO Section (S jack)
Input (Sensitivity/Impedance)
VCR 1/DVR, VCR 2, VIDEO, DVD/LD, TV/SAT
Luminance signal (Y) ............................... 1 Vp-p/75
Chrominance signal (C) ..................... 0.286 Vp-p/75
Output (Level/Impedance)
VCR 1/DVR, VCR 2, MONITOR OUT
Luminance signal (Y) ............................... 1 Vp-p/75
Chrominance signal (C) ..................... 0.286 Vp-p/75
Frequency Response
VCR 1/DVR, VCR 2, VIDEO, DVD/LD, TV/SAT
Luminance signal (Y) ................ 5 Hz to 10 MHz
Signal-to-Noise Ratio
Luminance signal (Y) ........................................ 65 dB
102
+0
dB
–3
(at volume position -40dB)
+0
dB
–3
Component Video Section
Input (Sensitivity)
Y ................................................................ 1 Vp-p/75
P /P ............................................................. 0.7 V/75
B R
Output (Level/Impedance)
Y ................................................................ 1 Vp-p/75
P /P ............................................................. 0.7 V/75
B R
Frequency Response
Y ................................................. 5 Hz to 40 MHz
P /P ............................................ 5 Hz to 40 MHz
B R
VIDEO Section (Composite)
Input (Sensitivity/Impedance)
VCR 1/DVR, VCR 2, VIDEO, DVD/LD,
TV/SAT ......................................................... 1 Vp-p/75
Output (Level/Impedance)
VCR 1/DVR, VCR 2, MONITOR OUT,
MONITOR OUT2 ......................................... 1 Vp-p/75
Frequency Response
VCR 1/DVR, VCR 2, TV/SAT, DVD/LD
VIDEO=MONITOR OUT, ............. 5 Hz to 10 MHz
Signal-to-Noise Ratio ................................................ 65 dB
FM Tuner Section
Frequency Range ........................... 87.5 MHz to 108 MHz
Usable Sensitivity ........ Mono: 13.2 dBf, IHF (1.3 µV/75 )
50 dB Quieting Sensitivity ......................... Mono: 20.2 dBf
Signal-to-Noise Ratio ................... Mono: 73 dB (at 85 dBf)
Distortion ........................................ Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity ................... 60 dB (400 kHz)
Stereo Separation ........................................ 40 dB (1 kHz)
Frequency Response ................. 30 Hz to 15 kHz (± 1) dB
Antenna Input ......................................... 75
AM Tuner Section
Frequency Range ............................ 530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna) ........................... 350 µV/m
Selectivity ................................................................. 25 dB
Signal-to-Noise Ratio ................................................ 50 dB
Antenna ........................................................ Loop antenna
Miscellaneous
Power Requirements ............................... AC 120 V, 60 Hz
Power Consumption ............................................... 600 W
Power Consumption in Standby mode .................... 0.6 W
AC Outlet SWITCHED ......................... 100 W (0.8 A) MAX
Dimensions .................... 420 (W)
(16-9/16 (W)
Weight (without package) ................... 17.3 kg (38 lb 3 oz)
Furnished Parts
FM wire Antenna ............................................................. 1
AM loop Antenna ............................................................. 1
"AA" IEC LR6 batteries .................................................. 2
Remote Control Unit ........................................................ 1
Operating Instructions .................................................... 1
NOTE:
Specifications and the design are subject to possible
modifications without notice, due to improvements.
+0
dB
–3
+0
dB
–3
+0
dB
–3
Stereo: 38.6 dBf
Stereo: 70 dB (at 85 dBf)
unbalanced
188 (H) 464 (D) mm
7-7/16 (H) 18-5/16 (D) in.)