Pioneer Elite VSX-43TX Operating Instructions Manual page 97

Audio/video multi-channel receiver
Hide thumbs Also See for Elite VSX-43TX:
Table of Contents

Advertisement

Symptom
Other audio problems
Subwoofer output is very
low.
During multi channel
playback, there is no sound
output from one speaker.
A multi channel DVD source
appears to be downmixed
from 2 channels during
playback.
Considerable noise in radio
broadcasts.
Broadcast stations cannot
be selected automatically.
Noise or hum can be heard
even when there is no sound
being input.
When a search is performed
by a DTS compatible CD
player during playback,
noise is output.
When playing a DTS format
LD there is noise audible on
the soundtrack.
Audio doesn't record (in
some cases, even if video
does).
Cause
• Settings route signal away from
subwoofer.
• That speaker is set to NO.
• The source is coming from something
other than the MULTI CH IN jacks (for
example, digital PCM output, etc.)
• Incorrect frequency.
• The antenna is not connected.
• Digital cables are near the antenna
terminals and wires.
• The antenna is poorly positioned.
• Interference caused by other equipment
(fluorescent lamp, motor, etc.).
• Weak radio signals.
• There is electrical interference from
another component or appliance.
• The search function performed by the
player interferes with the reading of digital
information.
• The SIGNAL SELECT is on ANALOG.
• You are trying to make an analog
recording from a digital signal, or a digital
recording of an analog source.
• The digital source is copy protected.
• The jacks for recording have not been
connected properly.
Techno Tidbits & Problem-solving
Remedy
• To get more signal to the subwoofer set
it to PLUS or choose SMALL for the front
speakers (see pages 37–38).
• Set the speaker to YES.
• Check the MULTI CH IN connection (see
page 20) and select the type of playback
with the MULTI CH IN button (see page 50).
• Tune in the correct frequency.
• Connect the antenna (see page 23).
• Route digital cables away from the
antenna terminals and wires.
• Adjust the direction and position for best
reception.
• Turn off the equipment causing the noise
or move it away from the receiver.
• Place the antenna farther away from the
equipment causing the noise.
• Connect an outdoor AM or FM antenna
(see page 23).
• Check that personal computers or other
digital components connected to the same
power source are not causing interference.
• This is not a malfunction, but be sure to
turn the volume down to prevent the output
of loud noise from your speakers.
• Set the SIGNAL SELECT to DIGITAL (see
page 42).
• You can only record analog to analog, or
digital to digital. Make sure the playback
and recording components are hooked up
with the same kind of connections.
• You can't record digital sources that have
been copy protected.
• Check connections (see pages 19 & 21).
97

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents