Getting Started; First Power Up; Powering On The Display; Powering Off The Display - Raymarine AXIOM Advanced Operation Instructions

3.1 Getting started

First power up

When you power up your new Multifunction Display (MFD) for the first time a number of actions
are required.
The list below shows the actions that should be performed on your new MFD:
1. Power on the display.
2. Select your Data master (only required on networks with more than 1 MFD).
3. Complete the Startup wizard (the wizard will not be shown if you are connecting to an existing
system that has already been set up).
4. Read and agree to the Limitations on Use disclaimer.
5. Select/check your preferred Data sources, if required.
6. Perform Engine identification, if required.
7. Select/check Transducer settings, if required

Powering on the display

When power is available to the MFD but the MFD is switched off, the Power symbol will be illuminated.
To power on the display:
1. Swipe your finger from left to right across the Power button swipe area.
The MFD will power up.

Powering off the display

1. Swipe your finger from left to right across the Power button swipe area.
The Shortcuts menu is displayed.
2. Press and hold the Power symbol until the screen switches off.
Note: When powered off, the unit may still draw a small amount of power from the battery, if this is
a concern unplug the power supply or switch off at the breaker.
16