Table of Contents
Advertisement
MAINTENANCE AND CLEANING
Warning: Switch o and disconnect from mains supply before
replacing, adjusting or cleaning your trimmer. Be aware that the
trimmer continues to rotate for a few more seconds after it has
been switched o .
To Store: Store it out of the reach of children, in a stable and safe position
and in a dry place where the temperature is not too hot or too cold.
• Store the trimmer away from direct sunlight, if possible in a dark or barely
lit place.
• Do not store in a nylon bag as this could encourage the formation of
damp patches.
• Do not store the grass trimmer resting on the oor. Hang it by the upper
handgrip instead, so that the guard does not touch anything. Ensure the
resting guard does not touch anything. The resting of the guard on a
surface could alter its shape and therefore its dimensions and safety
characteristics would be modi ed.
To Clean
• Regular cleaning and maintenance of you grass trimmer will ensure
e ciency and prolong the life of your machine.
• After each cutting operation, take apart and clean out the grass and soil
from; the spool and its slot, the whole trimmer and in particular the guard.
• During operation, keep the air vents clean and free of grass.
• Only use a cloth soaked with hot water and a soft brush to clean it.
• Do not spray or wet the appliance with water.
• Do not use detergents or solvents as these could ruin the trimmer. The
parts in plastic can easily be damaged by chemical agents.
• If the wire cutting blade no longer cuts or breaks, have this replaced by
contacting an authorised service center.
• Take special care to clean around the inside of cutting head guard, the
cap and motor housing cooling vents.
• Refer to quali ed service personnel if internal maintenance is required.
• CAUTION! The blade can give deep cuts.
TROUBLESHOOTING
PROBLEM
Line will not
1. Line is welded to itself.
advance when
2. Not enough line on spool.
you restart
3. Line is worn too short.
the machine.
4. Line is tangled on spool.
Cutting head is
Grass wrapped or built
hard to turn
up around head.
Grass wraps
Cutting tall grass at ground level.
around
the attachment
shaft and the
trimmer head
assembly
Liner trimmer
1) Unit failed
stops and will
2) Plug is damaged.
not start again
Waste electrical products should not be disposed of together
with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Separate collection of used products and packaging allow
materials to be recycled and used again. Reuse of recycled
materials helps prevent environmental pollution and reduces
the demand for raw material.
TECHNICAL SPECIFICATION
Voltage: 230/240Vac, 50Hz
Rated power: 550W
No load speed: 11000 rpm
Cutting line dia.: 1.5mm diameter
Cutting diameter: 270mm
Line length: 2 x 4.2m
Net Weight: 2.8Kg
Vibration value: 2.1 m/s
13
POSSIBLE CAUSE
1. Lubricate with a silicone spray.
2. Install more line (Refer to
"Replacing the Cutting Line" earlier
in this manual).
3. Pull lines while alternately pressing
down on and releasing bump button.
4. Remove line from spool and
rewind (Refer to "Replacing the
Cutting Line" earlier in this manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
1) Contact dealer to check damage
2) Check the plug
K= 1.5m/s
2
2
SOLUTION
14
Advertisement
Table of Contents
