Table of Contents
Advertisement
OPERATIONS
B. Replacing the spool kits.
1. Disconnect the mains plug.
2.Press together the both locking devices at the spool cover and remove
the latter.
3.Remove the thread spool kits from the spool cover.
4.Remove dirt and grass residues.
5.Thread the both cutting line ends of the new spool kits through the
holes of the impeller. (each one end through one hole) .
6.Firmly place the spool kits in the spool cover. Make sure that the cutting
line are not caught and pull them approx. 9 cm out of the spool.
7.Place the spool cover with spool kits on the impeller and press it rmly
down until the locking devices of spool cover securely click into place.
C. Conncet the Safety guard and wheel bracket rst.
1. Align the edging wheel bracket (12) with the safety guard (11);
2. Secure the edging wheel bracket and the safety guard with three screws
supplied.
3. Align the spigot of the edging wheel bracet-guard assembly with the
notch at the motor housing and place the bracket guard assembly on
the trimmer head.
OPERATIONS
4. Turn the bracket guard assembly along with the trimmer head
anticlockwise until it locks in place.
5. Secure the bracket guard assembly with the mounting bolt (16a),spring
washer(16b),and at washer(16c);
6. Carefully peel o the tape over the cutting blade.
WARNING! Never use the line trimmer unless the safety guard is
properly tted.
E. Assemble the Front handle.
1 - Press the locking button and hold, and then assemble the front handle;
2 - Secure it with the one screw supplied.
3 - If the operator want to adjust the handle position, do the step as
following:
a. please press the locking button(4) and then rotate the front
handle(3),
b. until the button clicks securely into locked position to a
comfortable working height, and then release it.
4
7
3
4
8
Advertisement
Table of Contents
