Blaupunkt GT4000 Instruction Manual page 3

GENERAL SAFETY WARNINGS
20. This electric tool is constructed in accordance with the relevant safety
requirements, Only experts may repair the electric tool. Otherwise, it may
endanger your life.
21. Voltage — make sure power supply is correct for your machine. The
voltage of this machine is on the rating plate.
Important : additional safety notes for your Grass Trimmer
22. During assembly take great care when tting the guard as this has a
very sharp cutting edge on one side for cutting the nylon line.
23. Never hold the cutter head above foot height or point it towards
people or animals when in use.
24. If the trimmer starts to vibrate excessively. Switch o immediately and
have it checked by a quali ed service engineer.
25. Caution: the cutting head continues to rotate for a few seconds after
switching o .
26. Always remove any sticks and stones etc. before using the trimmer.
27. Never run while using the trimmer.
28. Do not cross roads or gravel paths while operating trimmer.
29. On steep slopes cut across the slope, never in an up and down
direction.
30. Never t a metal replacement line.
31. Never use the trimmer while it is raining or in damp weather.
32. Use the trimmer in daylight or good arti cial light. Never use when
visibility is bad.
33. Do not overreach, keep proper footing and balance at all times.
DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY,
Do not use the lawn trimmer (edge trimmer), if the cords are damaged or
worn.
Wear stout shoes or boots to protect your feet.
Wear long trousers to protect your legs.
Before using the tool, check that your cutting path is free from sticks,
stones, wire and any other obstacles.
GENERAL SAFETY WARNINGS
Only use the tool in the upright position, with the cutting line near the
ground. Never switch the tool on in any other position.
Move slowly when using the tool. Be aware that freshly cut grass is damp
and slippery.
Do not work on steep slopes. Work across the face of slopes, not up and
down.
Never cross gravel paths or roads while the tool is running.
Never touch the cutting line while the tool is running.
Do not put the tool down until the cutting line has come to a complete
standstill.
Use only the appropriate type of cutting line. Never use metal cutting line
or shing line.
Be careful not to touch the line trimming blade.
Take care to keep the mains cable away from the cutting line. Always be
aware of the position of the cable.
Keep hands and feetaway from the cutting means at all times and
especially when switching on the motor.
Warning. Cutting wire continue to rotate after the motor is switched o .
Never operate the machine with damaged guards or without the guards
in place.
Always ensure that the ventilation openings are kept clear of debris.
Be familiar with the controls and the proper use of the equipment.
Only use the machine in daylight or good arti cial light.
Before use check the supply and extension cord for any signs of damage
or aging. If the cord becomes damaged during use, disconnect the cord
from the supply immediately.
3 4