Table of Contents
Advertisement
6
Let's start recording.
After pressing the [METRONOME] button, press the [REC] button to enter the record standby
mode. (Don't forget to check the amount of time available for recording.)
7
Press the [W/A] button to start recording. After the metronome's two measure count off, play
your guitar and record from the first measure of the song.
If the metronome is activated, recording will not actually start until after the
metronome's two-measure count off (from the third measure).
8
When you are finished recording, press the [W/A] button to stop recording.
The file you just recorded is automatically given a name and saved in the memory card.
File number
02/02
SONGå002
File name
* If the memory card becomes full while recording, due to a lengthy song or not enough memory in the
card to begin with, recording will automatically stop and a file will be created of the data recorded up
to that point.
* If, during the recording process, the SH-01's power is switched off, the memory card is removed, or an
error occurs, a file will not be created.
9
Press the [W/A] button to start playback.
Listen to the recording. If you are not pleased with the results, press the [UNDO/DELETE]
button to carry out the Undo (cancel) command and try recording again.
*When the SH-01 is switched OFF, or when the memory card is removed, UNDO is cleared and reset.
OK, are you satisfied with your recording?
Next, use the mix recording function and add a vocal part to your guitar part.
Since the recorded data is saved as a file in the memory card, you can quit recording and switch off
the SH-01 without any problem. Settings you made for the metronome, record mode, etc., are all
saved in the unit. If you want effect settings saved in the unit when power is switched off, set the
Effect Setup setting
(→ page 40)
Total number of files in the card
03:12
Total time of the selected file
to "BACKUP".
´
UNDO mark
Using the SH-01
23
Advertisement
Table of Contents
