Yamaha SH-01 Owner's Manual page 22

Using the SH-01
5
The SH-01 is also equipped with a metronome. Play your guitar along with the metronome
to keep the tempo steady.
Press and hold the [METRONOME] button until the metronome setup display shown below
appears. The metronome immediately starts and sounds in the manner that it is currently
setup. The [W/A] button lamp flashes in sync with the metronome (it flashes red on the first
beat of every measure and green on the remaining beats).
Press the [SELECT] button and flash the item (Tempo, Beat, Mode, Volume) that you want
to set, then use the [–]/[+] buttons to set the value or condition.
• TEMPO ................................. 30 – 250 (in 1-step increments) [Factory default: 120]
• BEAT .................................... 1/4, 2/4, 3/4, 4/4, 6/8 [Factory default: 4/4]
• Operating Mode (MODE) .... CONT., PRE. [Factory default: CONT.]
• Volume (VOL) ...................... 0-80 (1-step increments) [Factory Default: 30]
You can set the tempo, beat, and volume to whatever you like, but for this demonstration,
let's set the MODE to "CONT."
After making your settings, press the [ENTER] or [METRONOME] button to return to the
main display.
* Metronome settings are saved in the unit even when the power is switched OFF. If you want to hear the
metronome and you don't need to change any settings, simply press the [METRONOME] button to start
the metronome.
* The metronome does not function when Mix Recording.
22
Tempo
TEMPO:120
MODE:CONT.
Operating Mode
This setting determines when the metronome will operate and sound.
When set to PRE. (pre-count), the metronome only produces the beat
two measures before recording starts to give you the tempo before the
song starts.
The metronome will not sound while recording is paused.
While Stopped
New Recording Pre-count
During Recording
Beat
BEAT:4/4
VOL:30
Volume
CONT.
Sounds
Sounds
Sounds
PRE.
No Sound
Sounds
No Sound