Table of Contents
Advertisement
Effects are divided into eight categories depending upon their use. Since each category
contains eight effects the SH-01 offers a total of 64 effects for use. Refer to the
List " on page 42
for more information on each of the effects.
Select an effect category and effect type you would like to use.
Press the [SELECT] button until the item (category name or effect type) you want to set
flashes, then use the [–]/[+] buttons to select a category or type.
The effect that is shown in the display is active, so you can play your guitar and audition the
effect in real-time.
Also, the depth and amount of the effect being applied to the original sound is adjustable.
Press and hold the [EFFECT] button to show the parameter setting display for the currently
selected effect. Just as shown in the following illustration, two parameters can be adjusted
for each effect. Also, the reverb depth can be set for every effect.Refer to the
List " on page 42
for more information on each of the effect parameters.
Parameter 1
Parameter 2
Press the [SELECT] button to flash the item (Parameter 1, Parameter 2, Reverb) you would
like to set, and then use the [–]/[+] buttons to set the value.
* Hold the [–] button and press the [+] button to decrease the value by 10. Likewise, hold the [+] button
and press the [–] button to increase the value by 10. This method is useful when selecting a file or
setting a parameter.
Parameters 1 and 2 may differ depending upon the effect.
* If "DISTORTION" is selected in the effect category and sound is output through the internal speakers,
the unit vibrating may result in noise. We recommend that a pair of headphones or external speakers be
used when using the "DISTORTION" setting.
After you have completed making the necessary settings, press the [ENTER] button or [EF-
FECT] button and return to the main display.
4
You can also set the pan (the position in the stereo field) for the input source.
If you want to record two guitars, set the pan of one of the guitars to the right, and the other
to the left.
Press the [PAN] button to display the pan setting.
The flashing block (
move the position to the left (L) or right (R) then set. C indicates the center of the stereo field.
After you are finished setting the pan position, press the [ENTER] button or [PAN] button
and return to the main display.
DELAY: 64 REVERB: 64
MIX
: 64
~
) indicates the currently set pan position. Use the [–]/[+] buttons to
INPUT PAN
(-)L--~--C-----R(+)
Sound Position
Using the SH-01
"Effect Type
"Effect Type
Reverb Depth
21
Advertisement
Table of Contents
