Table of Contents
Advertisement
Using the SH-01
Using the Tuner Function
The SH-01's tuner has two operating modes.
• Tone Mode ...... Produces an audible pitch of the note selected from the 12 pitches, A - G#.
• Tuning Mode ... Displays the pitch closest to that which you play, and gives visual indica-
G Using the Tone Mode
1.
Press and hold the [TUNER] button to display
the tuner's main display.
Use the [–]/[+] buttons so that "TONE" appears
on the top half of the display (this selects the
tone mode).
An audible tone is produced and its volume
can be adjusted using the VOLUME control.
MODE:TONE
PITCH:440
2.
If it is necessary, press the [SELECT] button
to flash the pitch display, then use the [–]/[+]
button to set the standard pitch (435 - 446,
factory default=440)
3.
Press the [SELECT] button to flash the "VOL"
(volume) setting, and use the [–]/[+] button to
adjust the volume of the audible tone.
4.
Press the [TUNER] button to display the tone
mode setup display, then use the [–]/[+] but-
ton to flash the pitch you want to hear. The
pitch that you select is played.
TONE
P:440
Standard Pitch
5.
Press the [ENTER] button or [TUNER] button
to return to the main display.
* Tuner settings are saved in the SH-01 even when the power is switched OFF. If you want to use the tuner
again with the same settings, simply press the [TUNER] button.
24
tions as to whether the pitch is high or low.
VOL:30
Standard Pitch
Volume
(-)
(+)
F#G#A#BC#D#E
Pitch
G Using the Tuning Mode
1.
Press and hold the [TUNER] button to display
the tuner's main display.
Use the [–]/[+] buttons so that "TUNING" ap-
pears on the top half of the display (this se-
lects the tuning mode).
MODE:TUNING
PITCH:440
Standard Pitch
2.
If it is necessary, press the [SELECT] button
to flash the pitch display, then use the [–]/[+]
button to set the standard pitch (435 - 446,
factory default=440)
3.
Press the [TUNER] button to enter the tuning
mode display.
4.
In the tuner display, the tuner will flash the
name of the pitch that is closest to the tone
that is received by the unit's built-in micro-
phone, INST. jack, or LINE IN jack, and indi-
cate whether the pitch is high or low with the
display and the lighting the [W/A] button lamps.
Inaccurate display may occur due to the
*
input signal.
5.
Tune your instrument until the display indicates
that the pitch is in tune, as shown in the illus-
tration below.
TUNING F#G#A#BC#D#E
P:440----->>*<<-----
When the pitch is in tune
Standard
([W/A] lamp lights green)
Pitch
----->--*-------
When the pitch is low
([W/A] lamp lights red)
--------*--<----
When the pitch is high
([W/A] lamp lights red)
6.
Press the [ENTER] button or [TUNER] button
to return to the main display.
VOL:30
Volume
Advertisement
Table of Contents
