Setting Up the Reader
Setting Up the Reader
Follow the steps below to connect and get your reader up and
communicating with its host.
1.
Connect the Cable to the reader and the Host.
2.
Configure the Interface (see page 5).
3.
Configure the Reader starting on page 13 (optional,
depends on settings needed).
Connect/Disconnect Cable to Reader
Figure 1. Connecting to the Reader
Side View
Host Connection —
device as shown in
through an external power supply via the Interface Cable sup-
plied with a power jack.
Figure 2. Connecting to the Host
2
The QuickScan plugs directly into the host
Figure
2. The power can also be supplied
Side
View
Rear
View
QuickScan™ QD2430