Detaching And Refitting The High Voltage Pwb - Kyocera ECOSYS P3060dn Service Manual

(5) Detaching and refitting the high voltage PWB

Procedure
1. Remove the cassette.
2. Remove the right upper cover and the
right lower cover. (See page 1-5-4)
3. Remove the left upper cover and the left
lower cover. (See page 1-5-6)
4. Remove the power source fan motor.
(See page1-5-30)
5. Remove the power source PWB.
(See page1-5-25)
6. Stand the printer front side up.
7. Remove four screws each and then
remove the bottom plate 1 and the bot-
tom plate 2.
8. [60/55/50 ppm model only]
Release two hooks and then remove
the wire cover.
Pull the connector of lift sensor out.
Screw
Screw
Bottom plate 1
Screw
Screw
Bottom plate 2
Screw
Wire cover
Lift sensor
1-5-26
2T6/2T7/2T8/2T9
Screw
Figure 1-5-41
Connector
Figure 1-5-42
Screw
Screw
Hooks