Schematic Diagrams - Sharp LC-32LE631E Service Manual

SCHEMATIC DIAGRAMS

10. Schematic Diagrams
Description:
I
VOLTAGE MEASUREMENT CONDITION:
1. The voltages at test points are measured on the stable supply voltage of AC 230V. Signals are fed by a color bar
signal generator for servicing purpose and the above voltages are measured with a 20k ohm/V tester.
H
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
(K=k=1000 , M=M).
1. The unit of resistance "" is omitted.
2. All resistors are ± 5%, unless otherwise noted. (J= ± 5%, F= ± 1%, D= ± 0.5%)
3. All resistors are 1/16W, unless otherwise noted.
4. All resistors are Carbon type, unless otherwise noted.
G
: Solid : Cement
C
W
: Oxide Film : Special
S T
: Metal Coating
N
CAPACITOR
1. All capacitors are μF, unless otherwise noted. (P=pF=μμF).
F
2. All capacitors are 50V, unless otherwise noted.
3. All capacitors are Ceramic type, unless otherwise noted.
(ML): Mylar (TA): Tantalum
(PF): Polypro Film (ST): Styrol
CAUTION:
E
This circuit diagram is original one, therefore there may be a
slight difference from yours.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH " ! " (
IMPORTANT FOR MAINTAINING THE SAFETY OF
D
THE SET. BE SURE TO REPLACE THESE PARTS
WITH SPECIFIED ONES FOR MAINTAINING THE
SAFETY AND PERFORMANCE OF THE SET.
C
B
A
1 2 3
) ARE
4 5 6 7 8 9 10 11
95
12 13 14 15
LC-32LE631
LC-40LE631
LC-46LE631
16