Schematic Diagrams; Description; Indication Of Resistor & Capacitor; Rc Unit Diagram - Sharp LC-60LE635E Service Information

SCHEMATIC DIAGRAMS

Description:

VOLTAGE MEASUREMENT CONDITION:
1. The voltages at test points are measured on the stable supply voltage of AC 230V. Signals are fed by a color bar
signal generator for servicing purpose and the above voltages are measured with a 20k ohm/V tester.
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
(K=kΩ=1000 Ω, M=MΩ).
1. The unit of resistance "Ω " is omitted.
2. All resistors are ± 5%, unless otherwise noted. (J= ± 5%, F= ± 1%, D= ± 0.5%)
3. All resistors are 1/16W, unless otherwise noted.
4. All resistors are Carbon type, unless otherwise noted.
: Solid : Cement
C
W
: Oxide Film : Special
S T
: Metal Coating
N
CAPACITOR
1. All capacitors are μF, unless otherwise noted. (P=pF=μμ F).
2. All capacitors are 50V, unless otherwise noted.
3. All capacitors are Ceramic type, unless otherwise noted.
(ML): Mylar (TA): Tantalum
(PF): Polypro Film (ST): Styrol
CAUTION:
This circuit diagram is original one, therefore there may be a
slight difference from yours.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH " !
ARE
IMPORTANT FOR MAINTAINING THE SAFETY OF
THE SET. BE SURE TO REPLACE THESE PARTS
WITH SPECIFIED ONES FOR MAINTAINING THE
SAFETY AND PERFORMANCE OF THE SET.
" ( )

RC Unit Diagram

DUNTF494WE
I
H
G
F
Sharp Logo Unit Diagram
E
*D211
PXA189WJPZ
D
*P201
NA322WJ
LED_CTRL2
2
GND 1
@COMME
C
*D212
PXA189WJPZ
B
*D213
PXA189WJPZ
A
1 2 3
65
DUNTKF770WE53 1 / 3
*R211
130
1/10W DUNTKF770WE01
*R212
130
1/10W
*R213
130
1/10W
4 5 6
LC-60LE635
LC-60LE638
7