Sharp LC-32LE631E Service Manual page 25

Mechanical Instructions (continued)
5 tapes (80 mm)
3 tapes (150 mm)
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assy/Panel Removal Sundance Styling
(LC-xxLE631E series)
The instructions in this section also apply to the LC-
xxLE631E series.
For the 40" and 46" sets, additional instructions (rear cover
removal) apply. Refer to subsection
for 40/46LE631E and Removing of Major Parts.
The instructions apply to the 32LE631E.
4.3.1 Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
Note: it is not necessary to remove the stand while removing
the rear cover.
2 conductive tapes (40 mm)
2 x 11 mm clamp
Figure 4-2 Cable dressing LC-40/46LE631 series
Additional instructions
1. Remove all screws of the rear cover.
2. Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
Additional instructions for 40/46LE631E sets have a dedi-
cated method to open the bottom catches when removing
the rear cover.
Refer to Figure 4-4
1
Figure 4-4 Bottom catches 40" and 46" sets -1-
25
LC-32LE631
LC-40LE631
LC-46LE631
1 x 17 mm clamp
1 ferrite core
and Figure 4-5 for details.
19100_04 8_110216.eps
1
110315