Software Upgrading - Sharp LC-32LE631E Service Manual

LC-32LE631
LC-40LE631
LC-46LE631
Service Modes, Error Codes, and Fault Finding (continued)
5.9

Software Upgrading

5.9.1 Introduction
The set software and security keys are stored in a NAND-
Flash, which is connected to the PNX855xx.
It is possible for the user to upgrade the main software via the
USB port. This allows replacement of a software image in a
stand alone set, without the need of an E-JTAG debugger. A
description on how to upgrade the main software can be found
in the electronic User Manual.
Important: When the NAND-Flash must be replaced, a new
SSB must be ordered, due to the presence of the security keys!
(CI +, MAC address, ...).
Perform the following actions after SSB replacement:
1. Set the correct option codes (see sticker inside the TV).
2. Update the TV software => see the eUM (electronic User
Manual) for instructions.
3. Perform the alignments as described in chapter 6 (section
6.5 Reset of Repaired
4. Check in CSM if the CI + key, MAC address.. are valid.
Figure 5-13 SSB start-up
SOFTWARE UPGRADING
(see Table 6-6).
SSB).
For the correct order number of a new SSB, always refer to the
Spare Parts list!
5.9.2 Main Software Upgrade
• The "UpgradeAll.upg" file is only used in the factory.
Automatic Software Upgrade
In "normal" conditions, so when there is no major problem with
the TV, the main software and the default software upgrade
application can be upgraded with the "AUTORUN.UPG"
(FUS part of the one-zip file: e.g. 3104 337 05661 _FUS
_S5551_x.x.x.x_prod.zip).
_Q555X_ x.x.x.x_prod.zip). This can also be done by the
consumers themselves, but they will have to get their software
www.sharp-eu.com
from the commercial Philips website or via the Software Update
Assistant in the user menu (see eUM). The "autorun.upg" file
must be placed in the root of the USB stick.
How to upgrade:
1. Copy "AUTORUN.UPG" to the root of the USB stick.
2. Insert USB stick in the set while the set is operational. The
set will restart and the upgrading will start automatically. As
soon as the programming is finished, a message is shown
to remove the USB stick and restart the set.
Manual Software Upgrade
In case that the software upgrade application does not start
automatically, it can also be started manually.
How to start the software upgrade application manually:
1. Disconnect the TV from the Mains/AC Power.
2. Press the "OK" button on a SHARP TV remote control.
62
18753_211_100811.eps
100811
site