JVC NX-MD1R Service Manual page 8

NX-MD1R/NX-MD1
Removing the regulator board
Prior to performing the following procedure, remove
the top cover.
Prior to performing the following procedure, remove
the rear cover.
Prior to performing the following procedure, remove
the system control board.
Prior to performing the following procedure, remove
the main amplifier board.
1. Remove the two screws K and two screws L
attaching the regulator board.
2. Disconnect the wires from connectors CN903 and
CN995 on the regulator board.
Removing the AC jack board
Prior to performing the following procedure, remove
the top cover.
Prior to performing the following procedure, remove
the rear cover.
Prior to performing the following procedure, remove
the system control board.
Prior to performing the following procedure, remove
the main amplifier board.
Prior to performing the following procedure, remove
the regulator board.
1. Remove the screw M attaching the AC jack board.
2. Disconnect the wire from connector CN921 on the
AC jack board.
1-8
(See Fig.7)
Regulator
board
(See Fig.8)
CN921
Voltage
Selector
K
CN903
Fig.7
LF901
F9001
Fig.8
CN995
L
M
AC jack
board