JVC NX-MD1R Service Manual page 29

<Reattaching the loading assembly>
1. Reattach the eject bar to the UD base.
2. Reattach the slide bar to the loading mechanism
chassis while fitting the boss marked k to the eject
bar ditch k'. (Fig.21)
3. Slide the slide bar and the eject bar in the direction
of the arrow in Fig.21 and reattach the cartridge
holder assembly using the two screws J.
ATTENTION: Make sure the pin of the eject lever
marked m is fitted to the slot of the
eject bar marked n at the bottom of the
loading mechanism chassis after
moving the eject lever and the loading
slider of the cartridge holder assembly
in the direction of the arrow.
Ditch n
(Fig.15 and 21)
(Fig.21 and 22)
(Refer to Fig.22)
Slide bar
J
J
UD base (Bottom)
Cam switch board
q
Ditch k'
Eject bar
Fig.22
NX-MD1R/NX-MD1
H
Point marked
r
H
Cam switch boss
Boss k
UD base
Fig.21
Cartridge holder assembly
Loading slider
Eject lever
m
1-29