JVC NX-MD1R Service Manual page 12

NX-MD1R/NX-MD1
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
Prior to performing the following procedure, remove
the rear cover.
Prior to performing the following procedure, remove
the system control board.
Prior to performing the following procedure, remove
the main amplifier board.
Prior to performing the following procedure, remove
the MD mechanism assembly.
1. Remove the two screws X attaching the front panel
assembly from bottom side of the bottom chassis.
2. Release the three claws f on the bottom side of the
main body using screwdriver, and detach the front
panel assembly toward the front.
1-12
(See Fig.15)
Front panel assembly
X
Bottom chassis
Claw f
Fig.15