Technical Data - Zanussi ZDS 201 User Manual

The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the dishes.
There are streaks, milky stains, or a
bluish layer on glasses and dishes.
Dry water drop stains on glasses and
dishes.
The dishes are wet.
The dishes are wet and dull.

Technical data

Dimensions
Water supply pressure
1)
Water supply
Possible cause
The selected washing programme
was not applicable for the type of
load and soil.
The baskets were not loaded correct-
ly, water did not touch all surfaces.
The spray arms could not turn freely
because of incorrect arrangement of
the load.
The filters are dirty or not assembled
and installed correctly.
The quantity of detergent was not
sufficient or missing.
The salt container is empty.
Incorrect water softener adjustment
The salt container cap is not closed
correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause.
You have set a washing programme
without drying phase or with a de-
creased drying phase.
The rinse aid dispenser is empty.
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Possible solution
Make sure that the washing pro-
gramme is applicable for the type of
load and soil.
Load the baskets correctly.
Make sure that an incorrect arrange-
ment of the load does not cause a
blockage of the spray arms.
Make sure that the filters are clean
and correctly assembled and instal-
led.
Make sure that the quantity of deter-
gent is sufficient.
Fill the salt container with dishwasher
salt.
Adjust the water softener.
Make sure that the salt container cap
is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of detergent.
Let the door stay ajar for some mi-
nutes before you remove the dishes.
Fill the rinse aid dispenser with rinse
aid.
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
446 mm
850 mm
605 mm
13