Care And Cleaning; What To Do If - Zanussi ZDS 201 User Manual

Care and cleaning

To remove and clean the filters
Dirty filters decrease the washing results.
1
3
To remove filters B and C,
turn the handle approxi-
mately 1/4 counterclock-
wise .

What to do if...

The start of the appliance does not occur or it stops dur-
ing operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the service centre.
• The start/cancel indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The start/cancel indicator flashes continuously.
• The end indicator flashes two times intermittently.
• The start/cancel indicator flashes continuously.
• The end indicator flashes three times intermittently.
2
Clean the filters below
running water.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
Alarm code
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove re-
maining parts of soil with a thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and control
panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or
solvents (acetone).
With some malfunctions the indicators flash to show an
alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Malfunction
11