Zanussi ZDS 201 User Manual page 12

Warning! Deactivate the appliance before you do the
checks.
Malfunction
The appliance does not fill with water. The water tap is blocked or there is
The appliance does not drain the wa-
ter.
The anti-flood device is on.
The start of the washing programme
does not occur.
After the check, turn the programme knob on the same
washing programme before the malfunction occurred. The
programme continues from the point of interruption.
If the malfunction occurs again, contact the service centre.
If the different alarm codes show, contact the service cen-
tre.
The necessary information for the service centre is on the
rating plate.
12
Possible cause
limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose is
blocked.
The connection of the water inlet
hose is not correct.
The water inlet hose is damaged.
There is a blockage in the sink spi-
got.
The connection of the water drain
hose is not correct.
The water drain hose is damaged.
The appliance door is open.
You did not press the start/cancel
button.
The mains plug is not connected in
the mains socket.
The fuse in the fuse box is damaged.
The delay start is set.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
Possible solution
Clean the water tap.
Contact your local water authority.
Open the water tap.
Clean the filter.
Make sure that the connection is cor-
rect.
Make sure that the water inlet hose
has no damages.
Clean the sink spigot.
Make sure that the connection is cor-
rect.
Make sure that the water drain hose
has no damages.
Close the water tap and contact the
service centre.
Close the appliance door.
Press the start/cancel button.
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is comple-
ted, the washing programme starts
automatically.