Installing the 16Gb SAN Switch
For help identifying your specific enclosure setup and available connections, see the HP BladeSystem
c-Class Enclosure Setup and Installation Guide, provided with your enclosure, or the HP website
http://www.hp.com/go/bladesystem/documentation.
Install the Brocade 16Gb SAN Switch into the enclosure:
1.
Locate the appropriate interconnect bay in the rear of the enclosure.
CAUTION:
NOTE:
blank panels provided.
2.
Press the handle latch to release the installation handle.
Figure 3 Releasing the installation handle
1. Installation handle latched position
3. Installation handle released
NOTE:
device. The enclosure power may be on or off during installation.
3.
Align the Brocade 16Gb SAN Switch for HP BladeSystem c-Class with the appropriate
interconnect bay according to your enclosure's specific configuration. Push the switch firmly
into the interconnect bay.
12
Setup
Properly ground yourself before handling the switch.
Populate all enclosure interconnect bays with an interconnect module or one of the
The Brocade 16Gb SAN Switch for HP BladeSystem c-Class is a hot-pluggable
2. Handle latch