Carrier 52S Architects And Engineers' Manual page 20

ORDERING DATA (cont)
Accessory Retrofit Kit For
Amana/Trane Sleeve
Part No.: AM-RETROFIT-KIT
This kit contains the items that allow owners to install
a 52S chassis into an Amana or Trane sleeve so that
there is no air leakage or damage to 52S unit compo-
nents. The kit includes a bracket, foam baffles, screws,
side angles, a foam seal, and foam gaskets. The retro-
fit kit is an accessory and must be ordered separately
from the factory.
The installation requires adding a bracket to the wall
sleeve to ensure that the chassis will be level when it is
placed in the metal sleeve. Attach foam seal to front of
sleeve. Two foam baffles (provided in the Retrofit Kit)
are placed on the outdoor condenser coil tube sheets,
one baffle on each tube sheet. These baffles must be
installed to prevent air recirculation. Foam gaskets
added to the basepan prevent water leakage.
Refer to the installation instructions for complete
installation procedures.
Foam Baffles Attached on Outdoor Coil Tube Sheets
BASEPAN
NOTCH
LOCATION (2)
Gaskets Installed onto Basepan
IMPORTANT: Be sure that the foam baffles make a
good seal between the grille and outdoor coil tube
sheets. Improper installation of the foam baffles or
neglecting to install them can result in condenser (out-
door) air recirculation. This will degrade the unit's
performance and shorten product life. Do not ignore
this step. Carrier does not assume responsibility for
costs or damages resulting from misapplication of foam
baffles.
SLEEVE
INSTALLED
BRACKET
ATTACHED
FOAM SEAL
Bracket Attached to Amana/Trane Metal Sleeve
GASKETS
(2 EACH SIDE)
20