Table of Contents
Advertisement
Various Digital Signal Settings
Use the setup screen to make the "Audio" settings. Press the SETUP
button to display the setup screen, then operate as described under
"Making settings using the setup screen" on pages 60 and 61.
Dolby Digital signal settings
Dolby Digital is a "three-dimensional" audio technology used in movie theaters. It
allows recording of up to 5.1 channels of independent audio signals. There is no
need to make this setting if the "Digital Jack" setting has already been
made with the Setup Navigator.
Audio1
2
Video
Dolby Digital Out
DTS Out –
96kHz PCM Out –
MPEG Out –
i
Switch Dolby Digital audio mode
Move
Settings:
Dolby Digital*
Dolby Digital 3 PCM
DTS signal settings
DTS is another "three-dimensional" audio technology used in movie theaters. It
also allows recording of up to 5.1 channels of independent audio signals. DTS
offers somewhat different sound from Dolby Digital. There is no need to make
this setting if the "Digital Jack" setting has already been made with the
Setup Navigator.
Audio1
2
Video
Dolby Digital Out – Dolby Digital
DTS Out
96kHz PCM Out –
MPEG Out –
i
Switch DTS audio output mode
Move
Settings:
Off*
DTS
72
En
Language
General
Other
Dolby Digital
Dolby Digital 3 PCM
96kHz 3 48kHz
MPEG 3 PCM
SETUP
Exit
*Factory setting
Language
General
Other
Off
DTS
MPEG 3 PCM
Exit
SETUP
*Factory setting
• Dolby Digital: A Dolby Digital
compatible amplifier or decoder is
required to select this mode.
• Dolby Digital 3 PCM: The Dolby
Digital signals are converted into linear
PCM before being output. In this
mode a Dolby Pro-Logic amplifier or an
amplifier equipped with a digital input
can be used.
This setting can be changed during
playback.
• Off: DTS signals are not output.
• DTS: A DTS compatible amplifier or
decoder is required to select this
mode.
This setting can be changed during
playback.
Note:
The DTS-CD digital output cannot be turned
on and off.
Hide quick links:
Advertisement
Table of Contents
